2011-08-16, 23:29:20
(This post was last modified: 2012-12-23, 20:01:07 by Mikael Gustavsson.)
Hello!
I am trying to make the bootloader work with a 18F2525 and its internal oscillator.
I set it to 8 MHZ by setting OSCCON bits 6,5 and 4 to one and checking the "autobaud" in the software.
Some times works and some times doesn't.
So, is something that i have to further take care in software (e.g. configuration, settings) before i start check the circuit and other stuff?
Thank you very much in advance and thanks your sharing your amazing work with us!
I am trying to make the bootloader work with a 18F2525 and its internal oscillator.
I set it to 8 MHZ by setting OSCCON bits 6,5 and 4 to one and checking the "autobaud" in the software.
Some times works and some times doesn't.
So, is something that i have to further take care in software (e.g. configuration, settings) before i start check the circuit and other stuff?
Thank you very much in advance and thanks your sharing your amazing work with us!