+- ds30 Loader free edition forums (https://picbootloader.com/forum)
+-- Forum: Support (https://picbootloader.com/forum/forumdisplay.php?fid=3)
+--- Forum: 16-bit firmwares (https://picbootloader.com/forum/forumdisplay.php?fid=6)
+--- Thread: Very basic getting started guide (/showthread.php?tid=22569)
Very basic getting started guide - RGV250 - 2024-06-26
Hi,
I could not really find a place to post this, possibly need a general tab?
I keep looking from time to time about using a bootloader but I cannot get past the very simple thing on where to start. I have looked at the manuals and am still none the wiser. I have only used the Amicus18 with a bootloader and for that there was a bootloader file which was already created. What I seem to find with ds30 is the application where you select your project and download it but first the bootloader code must already be on the device.
This is the bit I am struggling to get past, it would be nice if there was an asm file with comments to show what needs to be configured or does the studio do that as well?
Once the bootloader file is on the device do you need to set all the configurations in studio everytime or can you save a configuration.
Regards,
Bob
RE: Very basic getting started guide - Mikael Gustavsson - 2024-06-28
Hi,
Did you read the usage section of the ds30 Loader main manual?
Regards
Mikael