dsPIC33FJ128GP710 [solved]

[medamarko]

Hi, i successfully edited dsPIC33 firmware.
And it is working on 256k baud.
But on every 2 minutes device is resetting.
If i load hex via ICSP everything is working fine.

I connected FTDI (FT232RL) board to UART2.

In Attach Im sending modified firmware.
Any help is appreciated.

Regards

[Mikael Gustavsson]

I don't see any problems with your modifications.
And it's very hard for me to figure out the problem.

You should try to determine the reset cause. There's
a register which I don't remember the name of which
will help you to do just that.

[medamarko]

POR was resetting by some reason. After Disabling this everything is working fine.
BTW RCON reg is reset control register
I will test it more for weekend.

Thanks

[Mikael Gustavsson]

Thanks for the report.