2011-10-14, 17:03:28
(This post was last modified: 2012-12-22, 00:47:22 by Mikael Gustavsson.)
Hi,
I have a firmware that works when I load it through an ICD3. When I try to load it through the bootloader it does not start up. I have run 2 other firmwares through the same boot loader, and when I load them on the current config they still work. It seems only this particular firmware doesn't work.
When I parse the hex file I get "There is no GOTO at location 0x00" which is not something I've seen before. Is this an error with my file or with the way the loader is reading it or what? Is there something in my other firmwares that I am unaware of that is not in the current one?
I should note that this is the first firmware I have used that has attempted to use the PLLx4 instead of the normal FRC.
Edit: I am also getting this error:
Hex file successfully parsedok
Detected instructions where user goto should be moved to
The hex-file contains more config words than the device has
Hex file successfully parsed
I am unsure what this means or what I need to fix to get it working correctly.
Thanks,
Greg
I have a firmware that works when I load it through an ICD3. When I try to load it through the bootloader it does not start up. I have run 2 other firmwares through the same boot loader, and when I load them on the current config they still work. It seems only this particular firmware doesn't work.
When I parse the hex file I get "There is no GOTO at location 0x00" which is not something I've seen before. Is this an error with my file or with the way the loader is reading it or what? Is there something in my other firmwares that I am unaware of that is not in the current one?
I should note that this is the first firmware I have used that has attempted to use the PLLx4 instead of the normal FRC.
Edit: I am also getting this error:
Hex file successfully parsedok
Detected instructions where user goto should be moved to
The hex-file contains more config words than the device has
Hex file successfully parsed
I am unsure what this means or what I need to fix to get it working correctly.
Thanks,
Greg