2011-12-16, 16:07:17
(2011-12-15, 23:40:02)Mikael Gustafsson Wrote: Hi Daniele,
Thank you for posting in the forum.
Can you enable debug mode and post a screenshot or the the text from the GUI.
Also post the hex file.
Thanks
Mikael
Hi Mikael,
thank You very much for your answer!
Below the error messages that appear after write.
.
.
.
Hex file successfully parsed
Writing flash...
Erasing page 0 0x0000...ok
Writing row 0 0x0000...verification error 1 try verification error 2 try write failed
Write flash failed
Closing port
Tx 73 bytes / Rx 8 bytes / 1,3s
Write failed
-------------------------------------------------------------------
In attached, ".hex" file and "screen shoot" of debug mode during write flash.
Best Regards, Dany.