2011-12-26, 19:32:31
Hi,
Thank you posting in the forum! Your config looks good as far as I can see.
The device id constants are 495 in both firmware and GUI so there seem
to be some sort of communication/timing problem.
Please post the entire output from the GUI or a screenshot.
Which RS485 converter do you use on the PIC side?
Which rs485 chip do you use on the PIC side?
Can you post the txenable enable code from your application? Email is ok.
Thank you posting in the forum! Your config looks good as far as I can see.
The device id constants are 495 in both firmware and GUI so there seem
to be some sort of communication/timing problem.
Please post the entire output from the GUI or a screenshot.
Which RS485 converter do you use on the PIC side?
Which rs485 chip do you use on the PIC side?
Can you post the txenable enable code from your application? Email is ok.