2012-01-17, 20:07:16
(2012-01-09, 21:27:28)Mikael Gustafsson Wrote: I'm sorry but I don't know what to make of it. It works fine in my tests using 886 which is practically identical.
Do this:
-Do a chip erase
-Verify erase
-Write boot loader
-Try to write once using the boot loader
-Read the entire flash
-Export it from MPLAB IDE
-Attach the hex file here.
Hi Mikael,
How Are You?...
I tried some methods but nothing is changed!... I don' t know why not work.
I tested Max232 circuit with a software in the Pic that Tx and Rx char, and It works. I tried others firmware to load in the Pic with BootLoader but appears the some error message.
In the attached the BootLoader.hex and the file.hex after a write.
Thank You very much for your patience and support.
Dany.