2010-11-29, 19:15:36
(This post was last modified: 2010-11-29, 19:18:54 by Mikael Gustavsson.)
I have not seen that before.
* Please send me screen-shot just after start-up (or attach to this thread if possible).
* If you delete/move all settings files, what output do you get in the gui just after start-up?
You can open the settings directory from the view menu in advanced mode.
* Have you read the errata to make sure there are no uart related problems?
* Try some other baud rates.
* If you have an oscilloscope, have a look at the uart lines to make sure it looks ok and at correct baud rate.
* Please send me screen-shot just after start-up (or attach to this thread if possible).
* If you delete/move all settings files, what output do you get in the gui just after start-up?
You can open the settings directory from the view menu in advanced mode.
* Have you read the errata to make sure there are no uart related problems?
* Try some other baud rates.
* If you have an oscilloscope, have a look at the uart lines to make sure it looks ok and at correct baud rate.