2010-11-29, 20:42:44
So ive noticed that the Baud rate options, upon start up, are reverting to the baud rates for the Canbus option. if i scroll to the canbus port the baud rate options are the same but then if i scroll back to the serial port, they go back to the standard serial port rates. deleting the setting files does not make a difference.
the only errata data for the uart talks about a potential error in 9 bit mode... i assume the boot loader is set up for 8 bit operation?
the attached scope picture is of 14400 baud rate transmitting to the chip. the same pattern appears every 500ms. does this look correct?
the only errata data for the uart talks about a potential error in 9 bit mode... i assume the boot loader is set up for 8 bit operation?
the attached scope picture is of 14400 baud rate transmitting to the chip. the same pattern appears every 500ms. does this look correct?