Hi! This is my first post here! I am trying to use your bootloader and so far I am facing a few problems. I am using a PIC16F877A micro and I made the apropriate changes at your MpLab files in order to meet my spesifications (UART selection, baud rate, main frequency etc). I am using an ICD3 in oder to program the bootloader.
Every time that I am programming the boolloader (using the ICD3) and then I am using for the first time your GUI to program the PIC everything is working perfectly! After that If I try to use again the GUI in order to program another hex file it says:
Searching for bl ........
and then time out.
I am reseting my PIC at the beginning or at the middle or at the end but always the same problem. If I reprogram again the bootloader using the ICD3 and then try to load a hex with your GUI it works perfectly for the first hex... but if I try another one nothing.
Any help?
Every time that I am programming the boolloader (using the ICD3) and then I am using for the first time your GUI to program the PIC everything is working perfectly! After that If I try to use again the GUI in order to program another hex file it says:
Searching for bl ........
and then time out.
I am reseting my PIC at the beginning or at the middle or at the end but always the same problem. If I reprogram again the bootloader using the ICD3 and then try to load a hex with your GUI it works perfectly for the first hex... but if I try another one nothing.
Any help?