2010-12-16, 04:40:52
(This post was last modified: 2012-12-22, 13:38:15 by Mikael Gustavsson.)
I'm currently getting a wrong pic detected error message saying it detected 254/selected 243 when I try to check for BL. I've commented out all the other devices so I know that the DEVICEID should be 243. Does this error at least mean that I'm communicating with the PIC?
I'm using PPS with pin39=UART1_TX and pin40=UART1_RX. I checked the datasheet to make sure that I was writing to the right registers for the PPS.
I've attached my PIC project. Any suggestions would be a great help.
TIA
I'm using PPS with pin39=UART1_TX and pin40=UART1_RX. I checked the datasheet to make sure that I was writing to the right registers for the PPS.
I've attached my PIC project. Any suggestions would be a great help.
TIA