2015-11-25, 00:28:52
(2015-11-24, 20:46:41)jcca Wrote: hello, in your settings file , do not select any mode available BRGH , you have two options to zero ( BRGH and BRG16 ) , you should be set to 1 of the two , or both , or activate the autobaud rate .
double check at your configuration bits, because not corresponding at the frecuence of the criystal and others options, that depend of your aplicattion.
regards.
Hi Jcca,
I did first of all use a baud rate calculator to find the values of BRGH and BRGH16 but had the same error. Then i just went through the combinations of both and had the same error on each occasion.
I have tried manually setting the config bits in MPLAB with the same error. I have also tried just compiling a flashing LED code with the same config settings (without the bootloader code) and this works as expected so i am satisfied the config is good.
So the upshot is im still scratching my head on this. Ill spend a little more time today and see what happens.
Thanks for your input :-)