2016-02-23, 18:37:06
Hi
I am not getting this to work no matter how hard I try. There was a thread that had some configuration settings but I lost it...
I tried setting USE_BRGH to 0 since that is what it is after reset and what the datasheet suggests also no luck.
I also tried varius PLL settings. The hardware uart works if PLL is enabled in the config word but 0 in osscon in Picbasic Pro.
To get this PIC's uart to work without the boot-loader is also tricky so I think I am missing a configuration setting or something.
tx
I am not getting this to work no matter how hard I try. There was a thread that had some configuration settings but I lost it...
I tried setting USE_BRGH to 0 since that is what it is after reset and what the datasheet suggests also no luck.
I also tried varius PLL settings. The hardware uart works if PLL is enabled in the config word but 0 in osscon in Picbasic Pro.
To get this PIC's uart to work without the boot-loader is also tricky so I think I am missing a configuration setting or something.
tx