Hi
I am having a problem when trying to get the DS30 Loader to communicated with a Pic 18F4620, I know that my RS232 comms is working as I have programmed other 16F devices.
Pic used 18F4620-E/P , 20 Mhz Crystal, Baud rate 115200, WDT Off, Low Power Disabled.
Initializing Download
searching for Bl............Time Out
I am pressing the reset switch connected to MCLR but it shows a time out.
I have gone into MPLAB IDE and set the configuration bits then exported the hex file out and used my programmer to load this into my Pic but when I use the DS30 loader to communicate with the Pic to load my hex file in to it I get the above mentioned problem.
I am using the latest version of DS30 & Gui loaded from the internet about a week ago.
Could someone Please help me and show me where I am going wrong ?
Regards
Craig
I am having a problem when trying to get the DS30 Loader to communicated with a Pic 18F4620, I know that my RS232 comms is working as I have programmed other 16F devices.
Pic used 18F4620-E/P , 20 Mhz Crystal, Baud rate 115200, WDT Off, Low Power Disabled.
Initializing Download
searching for Bl............Time Out
I am pressing the reset switch connected to MCLR but it shows a time out.
I have gone into MPLAB IDE and set the configuration bits then exported the hex file out and used my programmer to load this into my Pic but when I use the DS30 loader to communicate with the Pic to load my hex file in to it I get the above mentioned problem.
I am using the latest version of DS30 & Gui loaded from the internet about a week ago.
Could someone Please help me and show me where I am going wrong ?
Regards
Craig