2011-03-22, 21:09:50
Hi,
There are three supported ways of doing reset from ds30 Loader. Hardware reset (MCLR) using dtr or rts and software reset using a command on UART or CAN. It's up to your application to accept a reset command and perform the necessary steps to restart the controller. How do you use the UART in your application? Do you have any protocol implemented or do you only use the UART for boot loading?
There are three supported ways of doing reset from ds30 Loader. Hardware reset (MCLR) using dtr or rts and software reset using a command on UART or CAN. It's up to your application to accept a reset command and perform the necessary steps to restart the controller. How do you use the UART in your application? Do you have any protocol implemented or do you only use the UART for boot loading?