2011-04-19, 09:01:30
(2011-04-18, 19:32:28)Mikael Gustafsson Wrote: Which versions/package did you use before?
Do you use the same clock settings?
Have you read the errata?
The problem was caused by not exporting the hex file.
For the help of others. The .hex file created when you compile does not have the device configuration settings embedded. Thus if you attempt to use it with PK2CMD no device settings will be programmed.
In my case, I have an external 8MHz xtal, and because the configs were not set, the internal osc (also 8MHz) was enabled, but its baud rate was 17.1k (instead of 19.2) producing subtle com errors.