2014-07-16, 13:14:17
Hi,
I recently bought this USB HID host module, which has on board a 24FJ256GB106 PIC (manual ). I have soldered pins onto j2 connector, and connect txd (to the rxd of a usb to serial adapter) ,rxd (to the txd of a usb to serial adapter),+5v and ground, the led on the module turns red (which means that it's powered on). I also put pins to Mclr and ground signals of the j3 connector, in order to initiate program mode of pic.
I've tried ds30loader under win xp, but unfortunately every time i tried to flash the hex file, ds30loader wrongly recognize the 24FJ pic as dsPIC30F series. If i put 24FJ256GB106 by hand then it gives me a wrong pic selection message! I also know that usb to serial works ok, because i have successfully managed to flash a firmware to a gotek usb floppy emulator.
So, is there anything i can try/do?
I recently bought this USB HID host module, which has on board a 24FJ256GB106 PIC (manual ). I have soldered pins onto j2 connector, and connect txd (to the rxd of a usb to serial adapter) ,rxd (to the txd of a usb to serial adapter),+5v and ground, the led on the module turns red (which means that it's powered on). I also put pins to Mclr and ground signals of the j3 connector, in order to initiate program mode of pic.
I've tried ds30loader under win xp, but unfortunately every time i tried to flash the hex file, ds30loader wrongly recognize the 24FJ pic as dsPIC30F series. If i put 24FJ256GB106 by hand then it gives me a wrong pic selection message! I also know that usb to serial works ok, because i have successfully managed to flash a firmware to a gotek usb floppy emulator.
So, is there anything i can try/do?