2015-02-21, 11:16:26
Hi,
Has anyone here had any experience running PIC24F firmware upgrades "over the air" (OTA) using a bootloader?
I have a PIC24FJ128GA010 on a board in a product that is about 300Kms away and I need to eliminate the process by which I have to drive 600Kms to reflash the PIC
Five hours in a car, two minutes to reflash.....
I have never uused a bootloader before as I normally reflash using a PICKit3 in "Programmer on the go" mode.
In this case the product is permanently connected to an APN using a Simcom SIM900 quad band GSM engine.
Any help would be appreciated.
Graham
Durban
South Africa
Has anyone here had any experience running PIC24F firmware upgrades "over the air" (OTA) using a bootloader?
I have a PIC24FJ128GA010 on a board in a product that is about 300Kms away and I need to eliminate the process by which I have to drive 600Kms to reflash the PIC
Five hours in a car, two minutes to reflash.....I have never uused a bootloader before as I normally reflash using a PICKit3 in "Programmer on the go" mode.
In this case the product is permanently connected to an APN using a Simcom SIM900 quad band GSM engine.
Any help would be appreciated.
Graham
Durban
South Africa