2011-08-18, 22:49:20
Well, i have news.
Good news is that it worked.
What i did is i de-activated reset by RTS, i uncheck the 'auto baudrate', set the speed to 19200 and i manually reset the pic.
BUT there still exists a problem.
Some times it finds other pic than actually used and some times it finds nothing.
Since i think that it might be because of the fact that i am using the internal oscillator (so clocking might be bad), i will add a xtal (e.g. 8 MHZ) and i will come back with news.
Strange is that before i make the first write, by using auto baud rate and reset by RTS, it ALWAYS find the pic correctly.
After the first write action, the reset by RTS action stops working and then it does not recognize nothing any more. (then it needs hardware reset).
Until then, only by pressing the 'check for bl' it finds the pic. And by pressing the 'write' but only for one time.
Strange?
Good news is that it worked.
What i did is i de-activated reset by RTS, i uncheck the 'auto baudrate', set the speed to 19200 and i manually reset the pic.
BUT there still exists a problem.
Some times it finds other pic than actually used and some times it finds nothing.
Since i think that it might be because of the fact that i am using the internal oscillator (so clocking might be bad), i will add a xtal (e.g. 8 MHZ) and i will come back with news.
Strange is that before i make the first write, by using auto baud rate and reset by RTS, it ALWAYS find the pic correctly.
After the first write action, the reset by RTS action stops working and then it does not recognize nothing any more. (then it needs hardware reset).
Until then, only by pressing the 'check for bl' it finds the pic. And by pressing the 'write' but only for one time.
Strange?