Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
24HJ128GP504
#1
Hi,

I have a problem with implementing 16bit bootloader to PIC24HJ128GP504. I'd like to use internal oscillator (FRC) on 7,37Mhz (without PLL). RP14 is RX, RP15 is TX (I set their TRIS registers in user_code.inc and set PPS register values - is there anything else I have to set?)

GUI app tells this:
Initiating write...
      Searching for bl . The hardware detected a framing error.response timed out
      Found dsPIC30F3014
      Firmware version timed out
      Tx 1 byte / Rx 2 bytes / 6,3s
      Write failed

Why GUI founds dsPIC30F3014? Could it be timing error? (baud rates are same in settings.inc and gui - 9600 bauds)..

Thank you for your help Blush
   
.zip   firmware_16-bit.zip (Size: 78.93 KB / Downloads: 24)
Reply


Messages In This Thread
24HJ128GP504 - by juranek - 2015-12-09, 13:47:44
RE: 24HJ128GP504 - by Mikael Gustavsson - 2015-12-18, 20:40:48
RE: 24HJ128GP504 - by juranek - 2016-02-02, 21:42:15

Forum Jump:


Users browsing this thread: 1 Guest(s)