Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Option to reset from both RTS and DTR simultaneously.
I'd like to ask if there is a possibility to include an option in the next revision of the Loader to reset uC via RTS and DTR simultaneously. That option would be nice when using MCP2200 for USB-UART bridge from Windows, because there is a known issue with Windows drivers and RTS is toggled only whet DTR is toggled in the same moment.

Best Regards,
Mitko P.

PS: It turns out the issue with Microchip drivers is now solved. You could consider my request void!

I was not able to reset the uC via RTS signal because I had configured MCP2200 with "Enable CTS/RTS pins" option. This option actually makes CTS/RTS lines controlled by hardware (quite confusing!!!) and it is not possible to toggle RTS from software (i.e. ds30 Loader).

Now with CTS/RTS pins "not enabled" everything works like a charm and flash programming with ds30 Loader is stunningly fast and easy! Mike, thank you for the great product you share with us!

Messages In This Thread
Option to reset from both RTS and DTR simultaneously. - by selfy - 2014-09-15, 15:35:33

Forum Jump:

Users browsing this thread: 1 Guest(s)