Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
USE_TXENABLE 16F1783 timeout
#4
Hey again.

I think i was misleading abit.
I am using bootloader over UART to USB and it is working. Now since i plan to use it with UART to RS485 to USB i was testing out this tx enable pin. I am stil using UART to USB and i am just hoping to watch the tx enable pin on oscilloscope. But as you can see if i enable this option it will not get contact anymore.

I hope it is clearer now Smile

Thanks!
Peeter
Reply


Messages In This Thread
USE_TXENABLE 16F1783 timeout - by petspats - 2014-09-19, 15:44:01
RE: USE_TXENABLE 16F1783 timeout - by petspats - 2014-09-19, 16:56:25
RE: USE_TXENABLE 16F1783 timeout - by petspats - 2014-09-19, 18:45:20
RE: USE_TXENABLE 16F1783 timeout - by petspats - 2014-09-22, 07:35:37
RE: USE_TXENABLE 16F1783 timeout - by miklosch - 2014-09-22, 18:06:26
RE: USE_TXENABLE 16F1783 timeout - by miklosch - 2014-09-28, 01:16:10
RE: USE_TXENABLE 16F1783 timeout - by petspats - 2014-09-23, 09:21:01

Forum Jump:


Users browsing this thread: 1 Guest(s)