Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
18F4620 [abandoned]
#7
9600 is good to start with. You can read about brg16 in the uart section in the data sheet.

If you use a 20MHz crystal you should set the oscillator config to HS and not Ext rc, see section 2 in the data sheet.
Reply


Messages In This Thread
18F4620 [abandoned] - by craig - 2011-02-22, 14:42:16
RE: 18F4620 - by craig - 2011-02-23, 15:21:22
RE: 18F4620 - by Mikael Gustavsson - 2011-02-23, 20:31:16
RE: 18F4620 - by craig - 2011-02-24, 10:28:42
RE: 18F4620 - by Mikael Gustavsson - 2011-02-24, 20:45:44
RE: 18F4620 - by craig - 2011-02-24, 21:59:34
RE: 18F4620 - by Mikael Gustavsson - 2011-02-24, 22:21:24
RE: 18F4620 - by craig - 2011-02-25, 18:21:40
RE: 18F4620 - by Mikael Gustavsson - 2011-02-28, 22:10:23
RE: 18F4620 - by craig - 2011-03-01, 08:43:17
RE: 18F4620 - by Mikael Gustavsson - 2011-03-03, 22:38:13
RE: 18F4620 - by craig - 2011-03-04, 09:44:06
RE: 18F4620 - by Mikael Gustavsson - 2011-03-04, 20:15:37
RE: 18F4620 - by kvrbek - 2011-03-06, 19:32:24

Forum Jump:


Users browsing this thread: 1 Guest(s)