Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Searching for bl...
#1
Hi! This is my first post here! I am trying to use your bootloader and so far I am facing a few problems. I am using a PIC16F877A micro and I made the apropriate changes at your MpLab files in order to meet my spesifications (UART selection, baud rate, main frequency etc). I am using an ICD3 in oder to program the bootloader.

Every time that I am programming the boolloader (using the ICD3) and then I am using for the first time your GUI to program the PIC everything is working perfectly! After that If I try to use again the GUI in order to program another hex file it says:

Searching for bl ........
and then time out.

I am reseting my PIC at the beginning or at the middle or at the end but always the same problem. If I reprogram again the bootloader using the ICD3 and then try to load a hex with your GUI it works perfectly for the first hex... but if I try another one nothing.

Any help?
Reply


Messages In This Thread
Searching for bl... - by John76 - 2013-07-08, 15:14:21
RE: Searching for bl... - by Mikael Gustavsson - 2013-07-08, 21:14:53
RE: Searching for bl... - by John76 - 2013-07-09, 09:02:59
RE: Searching for bl... - by Mikael Gustavsson - 2013-07-13, 16:38:24
RE: Searching for bl... - by John76 - 2013-07-14, 17:41:01
RE: Searching for bl... - by Mikael Gustavsson - 2013-07-15, 11:59:04
RE: Searching for bl... - by John76 - 2013-07-15, 19:46:07
RE: Searching for bl... - by Mikael Gustavsson - 2013-07-15, 22:05:32
RE: Searching for bl... - by John76 - 2013-07-16, 12:25:51

Forum Jump:


Users browsing this thread: 1 Guest(s)