2013-08-21, 18:57:59
Hi,
I am trying to use the DS30 bootloader on a PIC18F46K20. I have modified the settings file as best as I could understand it and downloaded it to the PIC with a PICKIT2.
If I click on Check for BL I get, Found PIC18F46K20 fw ver. 3.0.2 every time, so I assume this is right so far.
Next I downloaded my application using the GUI and all was successful.
Initiating write...
Reseting device...ok
Searching for bl .
Found PIC18F46K20 fw ver. 3.0.2
Waiting for the boot loader to be ready...ok
Hex file successfully parsed
Writing flash....ok
Tx 56.3kB / Rx 1.5kB / 115.2s
Write successfully completed
However the problem I have is that the application doesn't start up.
There is nothing ticked in the advanced settings tab
The application is written in Flowcode, im not sure if I need to do anything in the application to make it start up after the bootloader has finished running.
Can you help me out ?
Im using version 1.5.7 of the GUI and Version 3.0.2 of the bootloader firmware.
I am trying to use the DS30 bootloader on a PIC18F46K20. I have modified the settings file as best as I could understand it and downloaded it to the PIC with a PICKIT2.
If I click on Check for BL I get, Found PIC18F46K20 fw ver. 3.0.2 every time, so I assume this is right so far.
Next I downloaded my application using the GUI and all was successful.
Initiating write...
Reseting device...ok
Searching for bl .
Found PIC18F46K20 fw ver. 3.0.2
Waiting for the boot loader to be ready...ok
Hex file successfully parsed
Writing flash....ok
Tx 56.3kB / Rx 1.5kB / 115.2s
Write successfully completed
However the problem I have is that the application doesn't start up.
There is nothing ticked in the advanced settings tab
The application is written in Flowcode, im not sure if I need to do anything in the application to make it start up after the bootloader has finished running.
Can you help me out ?
Im using version 1.5.7 of the GUI and Version 3.0.2 of the bootloader firmware.