Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Make change in Loader for dsPIC33FJ128GP802 MCU
(2013-09-05, 19:34:33)Mikael Gustavsson Wrote: Hi,
Sorry for the late reply. I've been on vacation.

PPS (peripheral pin select) is a feature on some PIC/dsPIC which allows peripherals to be mapped to different i/o pins. This must be configured properly for the boot loader to work. There is a template prepared for you in

Which pins do you use for rx and tx?

Ok, thanks for reply! Smile

I have learn on Datasheet the PPS.

Some detail: i have this board, but the Seller does not provide the bootloader of the System:

[Image: %24T2eC16F,!zQE9s3sqJV-BRlNgR!PkQ~~60_12.JPG]
[Image: 2im5nd.jpg]

I have 4 of these cards and I wanted to use them with a normal bootloader.

- The pin for UART are 21 and 22
- Not Crystal, but Internal FRC

My chip is dsPIC33FJ128 GP

[Image: 361000_2_5.jpg]

I have modified: with correct MCU line (dsPIC33FJ128GP)
Replaced .gld linker, with correct linker for my dsPIC.

Now I have to enter values ​​for the pins of the UART, in the

Messages In This Thread
RE: Make change in Loader for dsPIC33FJ128GP802 MCU - by Ultron - 2013-09-06, 14:44:11

Forum Jump:

Users browsing this thread: 1 Guest(s)