Posts: 3
Threads: 1
Joined: Aug 2012
2012-08-30, 12:46:58
(This post was last modified: 2012-12-25, 17:12:05 by Mikael Gustavsson.)
DS30Loader Version : 1.5.3 (engine 2.2.7)
Initiating write...
Searching for bl . . . . . . . . . . . . .
Found PIC18F25K20 fw ver. 5.4.11
Unknown firmware version
Tx 13 bytes / Rx 3 bytes / 6,2s
Write failed
I'm new to this, so any help is welcome
Posts: 623
Threads: 0
Joined: Nov 2009
I would recommend you to first try a different baud rate.
Posts: 3
Threads: 1
Joined: Aug 2012
2012-08-30, 13:17:11
(This post was last modified: 2012-08-30, 13:17:59 by zorka.)
(2012-08-30, 13:06:06)Mikael Gustavsson Wrote: I would recommend you to first try a different baud rate.
Everything, except 115200 gives
Initiating write...
Searching for bl . . . . . . . . . . . . . . . . . . . . timed out
Tx 20 bytes / Rx 0 bytes / 10s
Write failed
BTW, board is a XINO for pic v1.2
Posts: 3
Threads: 1
Joined: Aug 2012
(2012-08-30, 13:17:11)zorka Wrote: (2012-08-30, 13:06:06)Mikael Gustavsson Wrote: I would recommend you to first try a different baud rate.
Everything, except 115200 gives
Initiating write...
Searching for bl . . . . . . . . . . . . . . . . . . . . timed out
Tx 20 bytes / Rx 0 bytes / 10s
Write failed
BTW, board is a XINO for pic v1.2
Downgrading to ds30LoaderGui 1.3.14.0, ds30loader dll 1.5.0.0, seems to have fixed my problem.
Posts: 623
Threads: 0
Joined: Nov 2009
You might have got the wrong settings with the new GUI.
It stores it's setting in a different location than the old versions.
