problem with response of the bl

[jcca]

ok, before at everything, thanks for your good job with the bootloader, its a very good tool, and very useful,ok, i will try to explain my issue, in others post i can see the same issue, the response of the bl only works the first time, and then, when i try load another .HEX, the bl not work.

Also i can see, which the solution in most cases is the upgrade of the GUI, but, i have the last version (1.5.7), and not is the fix for this case.

My PIC, is 16F1936, Fosc is 20Mhz, the file settings work fine, i can compile, and i can program the firmware, i can load my aplication (.HEX),but the bootloader response only the first time.

My GUI,have the option of reset, because i not desire have the signal RTS for reset. but not work for find the response of the bootloader.

if i put the option reset for signal RTS, everything its ok, and work perfectly.
i dont know what happend, maybe its bad configuration for my part, or, i dont know.

exist another fix for this issue??
can you please explain me how can i do this??

sorry for my english.

[Mikael Gustavsson]

A reset command need to implemented in your application. Have you done that?

[jcca]

ok, its ready,everything was my fault, my interpretation of the function not was the correct,sorry, all works fine now,thanks