Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
18F26K22 [solved]
#7
(2011-07-08, 11:16:16)Mikael Gustafsson Wrote: Do you have the uart working in your application? If so how is the configuration different?
Make two cope snippets in the boot loader to:
1. Toggle led when data is received on rx
2. Send data on tx when a button is pressed or similarly.
This way you can see if bot rx and tx is not working

Yes UART1 works in my application.
I have tried turning off TXIE just in case that was the problem, but no change.
In bootloader, I can toggle an led on when receive using USART2, but when i try USART1 the led doesn't toggle on, suggesting USART1 not turned on or some other conflict
Reply


Messages In This Thread
18F26K22 [solved] - by hobbytronics - 2011-07-07, 14:14:52
RE: 18F26K22 - by Mikael Gustavsson - 2011-07-07, 14:46:32
RE: 18F26K22 - by hobbytronics - 2011-07-07, 15:16:01
RE: 18F26K22 - by Mikael Gustavsson - 2011-07-07, 22:17:26
RE: 18F26K22 - by hobbytronics - 2011-07-08, 11:08:53
RE: 18F26K22 - by Mikael Gustavsson - 2011-07-08, 11:16:16
RE: 18F26K22 - by hobbytronics - 2011-07-08, 14:27:39
RE: 18F26K22 - by Mikael Gustavsson - 2011-07-08, 15:51:10
RE: 18F26K22 - by hobbytronics - 2011-07-08, 16:31:40
RE: 18F26K22 - by Mikael Gustavsson - 2011-07-08, 23:22:36
RE: 18F26K22 - by Mikael Gustavsson - 2011-07-15, 16:46:18
RE: 18F26K22 - by strud - 2012-02-19, 20:37:45
RE: 18F26K22 - by Mikael Gustavsson - 2012-02-20, 22:33:07
RE: 18F26K22 - by ghu - 2012-03-25, 21:26:04
RE: 18F26K22 - by Tom-H-PIC - 2012-04-01, 23:23:07

Forum Jump:


Users browsing this thread: 1 Guest(s)