Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
PIC12F1840
#1
Hi

I am not getting this to work no matter how hard I try.  There was a thread that had some configuration settings but I lost it...

I tried setting USE_BRGH to 0 since that is what it is after reset and what the datasheet suggests also no luck.

I also tried varius PLL settings.  The hardware uart works if PLL is enabled in the config word but 0 in osscon in Picbasic Pro.

To get this PIC's uart to work without the boot-loader is also tricky so I think I am missing a configuration setting or something.

tx


Attached Files
.zip   ds30 12f1840 8mHz 9600 baud.zip (Size: 56.87 KB / Downloads: 7)
Reply


Messages In This Thread
PIC12F1840 - by Mr_Booo - 2016-02-23, 18:37:06
RE: PIC12F1840 - by Mikael Gustavsson - 2016-03-02, 16:22:55
RE: PIC12F1840 - by Mr_Booo - 2016-03-07, 16:23:25
RE: PIC12F1840 - by Mikael Gustavsson - 2016-03-09, 09:22:32

Forum Jump:


Users browsing this thread: 1 Guest(s)