Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
PIC24FJ (usb host 2.1)
#1
Hi,
I'm following these instructions (http://www.hobbytronics.co.uk/usb-host/u...t-board-v2) in order to program the device (an usb host 2.1) with the latest serial firmware. Should I necessarly connect the reset pin after pushing the write button in the GUI, or can I just unplugged the wires, and the supply to device, to make it work?

Thank you in advance,
Antonio
Reply
#2
Hi Antonio,
Please turn to Hobbytronics.

Regards
Mikael
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)