18F25K20 again ?

[Mikael Gustavsson]

I cannot spot any problem with your code. I assume that the uart is working in your application. Try these changes:

1.
-change baud rate to 9600

2.
-enable brg16

3.
-change baud rate to 9600
-enable auto baud rate detectio in both fw and gui

4. Check oscillator frequency. Test code is available in ds30loader.s:

Code:

        ; Toggle pin, frequency on pin = PIC frequency / 16
        if 0
            bcf    TRISx, TRISxx
tsfloop        bsf LATx, LATxx
            bcf LATx, LATxx
            bra tsfloop
        endif