Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
dsPIC33FJ128GP710 [solved]
#1
Question 
Hi, i successfully edited dsPIC33 firmware.
And it is working on 256k baud. Smile
But on every 2 minutes device is resetting.
If i load hex via ICSP everything is working fine.

I connected FTDI (FT232RL) board to UART2.

In Attach Im sending modified firmware.
Any help is appreciated.

Regards


Attached Files
.zip   firmware dsPIC33FJ128GP710.zip (Size: 61.6 KB / Downloads: 51)
Reply
#2
I don't see any problems with your modifications.
And it's very hard for me to figure out the problem.

You should try to determine the reset cause. There's
a register which I don't remember the name of which
will help you to do just that.
Reply
#3
POR was resetting by some reason. After Disabling this everything is working fine.
BTW RCON reg is reset control register Smile
I will test it more for weekend.

Thanks
Reply
#4
Thanks for the report.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)