Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
P24FJ256GA106 UART Help
#1
Hello,

I am trying to set up a bootloader for the P24FJ256GA106. I have followed the instructions and browsed the forums as much as I can. My problem is with the UART not connecting to the PIC. I have successfully programmed the PIC with the bootloader but when I go to write to the PIC from the ds30 GUI, it times out when searching for BL.

I'll attach a zip of the program to show how I have it currently set up.

Any help is appreciated.

Thanks.


Attached Files
.zip   bootloader.zip (Size: 18.16 KB / Downloads: 27)
Reply
#2
Hi,
Is the UART working in your application?
What does your crystal/oscillator setup look like?
Reply
#3
Yes, the UART works well in the application.
The setup uses an external 32MHz oscillator.

Thanks for the reply.
Reply
#4
Which pins do you use for rx and tx?
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)