2016-09-08, 12:53:35
Hi,
I'm following these instructions (http://www.hobbytronics.co.uk/usb-host/u...t-board-v2) in order to program the device (an usb host 2.1) with the latest serial firmware. Should I necessarly connect the reset pin after pushing the write button in the GUI, or can I just unplugged the wires, and the supply to device, to make it work?
Thank you in advance,
Antonio
I'm following these instructions (http://www.hobbytronics.co.uk/usb-host/u...t-board-v2) in order to program the device (an usb host 2.1) with the latest serial firmware. Should I necessarly connect the reset pin after pushing the write button in the GUI, or can I just unplugged the wires, and the supply to device, to make it work?
Thank you in advance,
Antonio