Posts: 2
Threads: 1
Joined: Sep 2013
Hi All,
I have a 18F2331 with a FTDI FT232R USB to a Serial IC. Currently, I am using the INTOSC at 8 MHz. Are there any known issues with this set up? I managed to get the boot loader to work, but not self reset using RTS.
I did a search, but didn't find anything
Regards
John
Posts: 623
Threads: 0
Joined: Nov 2009
Hi,
Please link to the FTDI datasheet and post the relevant schematics.
Thanks
Mikael
Posts: 2
Threads: 1
Joined: Sep 2013
(2013-09-23, 21:39:41)Mikael Gustavsson Wrote: Hi,
Please link to the FTDI datasheet and post the relevant schematics.
Thanks
Mikael
Hi Mikael, thanks for the swift reply. FT232 link below.
http://www.ftdichip.com/Support/Document...UM232R.pdf
I have a 4K7 pull-up on the MCLR, and a 2N3904 in open-collector configuration, with the base connected to the FT232 RTS pin, via a 1K resistor.
Sorry I can't send a schematic at the moment, I'm replying from my ipad.
Regards
Posts: 623
Threads: 0
Joined: Nov 2009
There is a working schematic sample on page 21 in the main manual:
http://ds30loader.com/documentation/ds30...manual.pdf
Is your setup something similar? If you have a scope, take a look at the mclr pin while resetting.
Have you enabled reset by rts in ds30 Loader GUI?
BR
Posts: 623
Threads: 0
Joined: Nov 2009
