dspic30f6014 bootloader

[erdinc]

Hello,
I am using DSPIC30f6014. After I load the bootloader hex code via ICD once, I want to load my code via RS232. For this reason, I want to use ds30loader. I downloaded it from this forum.
My question is:
1-I load the bootloader code via ICD3. Then I try to check for the bootloader on ds30loader. But it cannot find the bootloader. What can be the problem?

[Mikael Gustavsson]

Hi,
Check the configuration bits and boot loader settings in settings.inc.

[xmwang]

Got the same problem here. Here is the message on ds30 GUI
Reseting device...ok
Searching for bl . . . . . . . . . . . . . . . . . . . . . timed out

Try both auto detect baud rate or use defined baud rate 9600, can not work

[xmwang]

Debugger see:
when call user_code.inc, it return to "__reset:mov #__SP_init, WSTPTR".