Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
PIC24FJ128GA010 Configuration Error [solved]
#1
Hi,

I complied my project with Mplab C30. Configuration_bits box was checked.And then i download the firmware to the pic by pickit2.
when i tried to connect with bootloader i got an error "Last row containing configs was found in hex file, last page has been disabled. Consult manual for more information.".

Thanks.
Reply
#2
Hi,
I'm sorry, I will get back to this thread when the documentation is updated.
Reply
#3
The trouble shooting sectio now contains an explanation of this message:
[broken link]
Reply
#4
Hi,
Thanks for your reply.I tried all the combinations of the communication changes, but i haven't got any response from the GUI.The board that i am using needs to be remap like RF5/RP17->> U2TX and RF4/RP10 ->> U2RX.I have only tomorrow to finish this issue.Thanks for your replies.If you can help me, I will be appreciated.

Best Regards.

Berkay.
Reply
#5
I told you, that device does not have PPS. All pins are fixed.
Continue and answer in the thread where I gave you trouble shooting guidance.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)