Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
FTDI FT232
#1
Hi All,
I have a 18F2331 with a FTDI FT232R USB to a Serial IC. Currently, I am using the INTOSC at 8 MHz. Are there any known issues with this set up? I managed to get the boot loader to work, but not self reset using RTS.
I did a search, but didn't find anything

Regards
John
Reply
#2
Hi,
Please link to the FTDI datasheet and post the relevant schematics.

Thanks
Mikael
Reply
#3
(2013-09-23, 21:39:41)Mikael Gustavsson Wrote: Hi,
Please link to the FTDI datasheet and post the relevant schematics.

Thanks
Mikael

Hi Mikael, thanks for the swift reply. FT232 link below.

http://www.ftdichip.com/Support/Document...UM232R.pdf

I have a 4K7 pull-up on the MCLR, and a 2N3904 in open-collector configuration, with the base connected to the FT232 RTS pin, via a 1K resistor.
Sorry I can't send a schematic at the moment, I'm replying from my ipad.

Regards
Reply
#4
There is a working schematic sample on page 21 in the main manual:
http://ds30loader.com/documentation/ds30...manual.pdf

Is your setup something similar? If you have a scope, take a look at the mclr pin while resetting.
Have you enabled reset by rts in ds30 Loader GUI?

BR
Reply
#5
Start a new thread.
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)